Windows
How to Clean Window Tracks and Sills
How to clean window tracks: vacuum first, loosen the grime, scrub the corners, clear the weep holes. Plus mold on sills and lubricating a sticky track.
Vacuum the dry dirt out first, then loosen what’s left with warm soapy water and a brush, wipe the corners clean, and clear the drainage holes. Doing it in that order keeps you from turning loose dust into mud.
What you need
- A vacuum with a crevice tool
- Warm water with a few drops of dish soap in a spray bottle
- An old toothbrush or a stiff detail brush
- Rags or paper towels
- A butter knife or flat screwdriver to push a rag into the corners
- A paper clip or pipe cleaner for the weep holes
Steps
- Vacuum the track dry. Get the pine needles, dead bugs and grit out before anything gets wet.
- Spray the track with the soapy water and let it sit two or three minutes to soften the grime.
- Scrub with the toothbrush, working the bristles into the corners and along the rails.
- Wipe it out. Wrap a rag around the butter knife and run it along the channel and into each corner. Repeat with a clean section until the rag comes out clean.
- Clear the weep holes. Sliding windows have small slots on the outside edge of the track that let rainwater drain out. Push a paper clip or pipe cleaner through each one. A blocked weep hole is why water sits in the track after a storm.
- Dry everything and open and close the window a few times.
For heavy buildup, a mix of equal parts white vinegar and warm water works better than soap. Let it sit five minutes before scrubbing.
Mold on the sill
Black spots on a sill or in the corners of a track are almost always mold fed by condensation. Wear gloves, scrub with mild detergent or the vinegar mix, and dry it completely. Bleach can discolor wood and painted sills, so skip it there.
Mold comes back as long as water keeps collecting. If your windows fog up every winter morning, start with how to stop condensation on windows.
A sticky track
Once it’s clean and dry, a light coat of silicone spray or dry lubricant makes a slider glide again. Avoid oil and grease. They stay tacky and collect dust, and the track ends up dirtier than before.
How often
Twice a year is plenty for most homes, at the same time as the glass. Homes under pines or near a dirt road may want a spring check after the windy season.
Sills get wiped as part of our window cleaning, along with the screens, inside and out.
Quick answers
- What is the best thing to clean window tracks with?
- A vacuum with a crevice tool for the dry debris, then warm water with a little dish soap, an old toothbrush, and a cloth wrapped around a butter knife or flat screwdriver for the corners.
- How do you get rid of mold on a window sill?
- Wear gloves, scrub it off with a mild detergent or a mix of equal parts white vinegar and water, and dry the sill completely. Then fix the cause, which is usually condensation running down the glass every morning.
- What should you lubricate window tracks with?
- A silicone spray or dry lubricant. Oil-based products and grease stay sticky and collect dust, which is what made the track stiff in the first place.